nuclear receptor is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-01-23. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
For long-term storage, SR9009 is typically kept as a solid at low temperature, protected from moisture and light. Desiccated conditions limit hydrolysis, while opaque containers reduce photochemical breakdown. Solutions are less stable than solids and are often stored frozen in aliquots to avoid repeated freeze-thaw cycles. Stability data are not standardized across all suppliers, so users should rely on certificate-of-analysis information when available. Degradation may appear as color change, precipitate, or decreased chromatographic purity.
In laboratory settings, SR9009 is typically characterized by liquid chromatography–mass spectrometry (LC-MS) or high-performance liquid chromatography with ultraviolet detection (HPLC-UV). These methods can confirm identity and estimate purity, but they require reference standards for accurate quantification. Because SR9009 is not a licensed pharmaceutical, no harmonized pharmacopeial monograph exists. Laboratories often validate in-house methods for matrices such as plasma, urine, or cell culture media. Sample preparation may involve protein precipitation or liquid-liquid extraction before analysis.
Physicochemical behavior influences handling. SR9009 is described as a solid with limited aqueous solubility, so organic solvents such as dimethyl sulfoxide or ethanol are common in research stock solutions. Aqueous dilution can produce precipitates if the organic content is too low. Light, heat, and repeated freeze-thaw cycles may affect stability. Storage recommendations usually specify a desiccated freezer environment protected from light, but exact stability data depend on the formulation and matrix.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water; stock solutions use organic solvent. |
| Storage | -20°C, desiccated, protected from light | Limits hydrolysis and photodegradation. |
| Analytical method | HPLC-UV/MS | Used for identity and purity assessment. |
| Synonyms | SR9009, Stenabolic | Naming varies by supplier. |
SR9009 is a synthetic small molecule studied as an agonist of REV-ERB nuclear receptors. REV-ERB alpha and REV-ERB beta help regulate circadian rhythms and metabolic gene expression. In laboratory research, SR9009 has been used to probe how these receptors affect skeletal muscle, liver, and adipose tissue. The compound was identified in academic drug-discovery work and is often described in scientific literature by its chemical name and research code. It is not an approved medicine, and human clinical data remain limited or absent.
SR9009 binds REV-ERB receptors and alters their repressive activity on target genes. This action can change transcription of genes involved in lipid handling, glucose metabolism, and mitochondrial function. In rodent studies, treated animals have shown changes in muscle oxidative capacity and exercise performance, though effects vary by dose, duration, and model. The precise molecular steps connecting receptor binding to whole-body outcomes are still an active area of investigation. Findings in animals do not automatically translate to humans.
SR9009 is a synthetic small molecule studied as an agonist of the nuclear receptors REV-ERBα and REV-ERBβ, also called NR1D1 and NR1D2. These receptors help regulate circadian rhythms and metabolic gene programs. The compound was developed for laboratory research, not as an approved therapeutic. Its identity is distinct from steroid hormones and selective androgen receptor modulators. Scientific interest centers on how REV-ERB activation changes gene expression in cells and animal models.
At the molecular level, SR9009 binds the ligand-binding domain of REV-ERB and strengthens recruitment of corepressor proteins such as NCoR and HDAC3. This increases repression of target genes, including Bmal1 and other clock-controlled and metabolic genes. In rodent studies, such changes have been linked to altered lipid handling, glucose metabolism, and energy expenditure. The precise chain of events between receptor binding and whole-body effects remains an active area of research. Findings in animals do not automatically translate to humans.
SR9009 is supplied as a solid research chemical, often in milligram quantities. Laboratories typically weigh it in a controlled environment because fine powders can disperse. Stock solutions are commonly prepared in dimethyl sulfoxide and stored in small aliquots to reduce freeze-thaw cycles. Personal protective equipment and chemical fume hoods are standard when handling unknown or potent compounds. These practices address laboratory safety rather than human use.
Identity and purity of SR9009 samples are usually checked with chromatographic and spectrometric methods. High-performance liquid chromatography can separate the compound from related impurities, while mass spectrometry provides molecular mass confirmation. Nuclear magnetic resonance spectroscopy may be used for structural verification in research settings. No single method proves biological activity, and certificates of analysis should be reviewed alongside raw data. Independent testing is often needed because online products vary widely.
Pizotifen is a serotonin antagonist acting mainly at the 5-HT2A, 5-HT2B, and 5-HT2C receptors. It also has some activity as an antihistamine as well as some anticholinergic activity. The drug binds non-selectively to many targets, including serotonin, dopamine, adrenergic, histamine, and muscarinic acetylcholine receptors. Besides its serotonin 5-HT2 receptor antagonism, pizotifen is a low-potency moderate-efficacy partial agonist of the serotonin 5-HT1A receptor. Pizotifen is able to dose-dependently and fully antagonize the discriminative stimulus effects of the serotonin–norepinephrine–dopamine releasing agent and serotonin 5-HT2 receptor agonist MDMA in rodent drug discrimination tests. Conversely, the related drug cyproheptadine was only partially effective and clozapine was ineffective. All three of these agents, pizotifen, cyproheptadine, and clozapine act as non-selective monoamine receptor antagonists. Pizotifen also fully blocks the effects of serotonergic psychedelics, including LSD, mescaline, 5-MeO-DMT, and DOM, in drug discrimination tests. The antimigraine activity of pizotifen might be specifically due to serotonin 5-HT2B receptor blockade.
==== 2004–2008 ==== In June 2004 and again in December 2005, the JINR–LLNL collaboration strengthened their claim for the discovery of element 113 by conducting chemical experiments on 268Db, the final decay product of 288115. This was valuable as none of the nuclides in this decay chain were previously known, so that their claim was not supported by any previous experimental data, and chemical experimentation would strengthen the case for their claim, since the chemistry of dubnium is known. 268Db was successfully identified by extracting the final decay products, measuring spontaneous fission (SF) activities and using chemical identification techniques to confirm that they behave like a group 5 element (dubnium is known to be in group 5). Both the half-life and decay mode were confirmed for the proposed 268Db which lends support to the assignment of the parent and daughter nuclei to elements 115 and 113 respectively. Further experiments at the JINR in 2005 confirmed the observed decay data. In November and December 2004, the Riken team studied the 205Tl + 70Zn reaction, aiming the zinc beam onto a thallium rather than a bismuth target, in an effort to directly produce 274Rg in a cross-bombardment as it is the immediate daughter of 278113. The reaction was unsuccessful, as the thallium target was physically weak compared to the more commonly used lead and bismuth targets, and it deteriorated significantly and became non-uniform in thickness. The reasons for this weakness are unknown, given that thallium has a higher melting point than bismuth.
Myomeres are blocks of skeletal muscle tissue arranged in sequence, commonly found in aquatic chordates. Myomeres are separated from adjacent myomeres by fascia consisting of connective tissue, known as myosepta. Myomere counts are sometimes used for identifying specimens using meristics, since their number corresponds to the number of vertebrae in the adults. Myomere location varies, with some species containing these only near the tails, while some have them located near the scapular or pelvic girdles. Depending on the species, myomeres could be arranged in an epaxial or hypaxial manner; hypaxial refers to ventral muscles (those of the "stomach" region) and related structures, while epaxial refers to more dorsal muscles (those of the "back"). The horizontal septum divides these two regions in vertebrates from cyclostomes (jawless lamprey and hagfish) to gnathostomes (jawed fish). In terrestrial chordates, which are gnathostomes themselves, the myomeres become fused as well as indistinct, due to the disappearance of myosepta.
Sources: en.wikipedia.org
Residency or postgraduate training is a stage of graduate medical education. It refers to a qualified physician (one who holds the degree of MD, DO, MBBS/MBChB), veterinarian (DVM/VMD, BVSc/BVMS), dentist (DDS or DMD), podiatrist (DPM), optometrist (OD), pharmacist (PharmD), physical therapist (DPT), or Medical Laboratory Scientist (Doctor of Medical Laboratory Science) who practices medicine or surgery, veterinary medicine, dentistry, optometry, podiatry, clinical pharmacy, physical therapy, or Clinical Laboratory Science, respectively, usually in a hospital or clinic, under the direct or indirect supervision of a senior medical clinician registered in that specialty such as an attending physician or consultant. The term residency is named as such due to resident physicians (resident doctors) of the 19th century residing at the dormitories of the hospital in which they received training. In many jurisdictions, successful completion of such training is a requirement in order to obtain an unrestricted license to practice medicine, and in particular a license to practice a chosen specialty. In the meantime, they practice "on" the license of their supervising physician. An individual engaged in such training may be referred to as a resident physician, house officer, registrar or trainee depending on the jurisdiction. Residency training may be followed by fellowship or sub-specialty training.
== Properties == N-Hydroxyphthalimide exists in two polymorphs, colorless and yellow, In the colorless white form, the NOH group is rotated about 1.19° from the plane of the molecule, while in the yellow form it is much closer to planarity (0.06° rotation). The color of the synthesized N-hydroxyphthalimide is determined by the solvent used; the color transition from white to yellow is irreversible. N-Hydroxyphthalimide forms strongly colored, mostly yellow or red salts with alkali and heavy metals, ammonia and amines. Hydrolysis of N-hydroxyphthalimide by the addition of strong bases produces phthalic acid monohydroxamic acid by adding water across one of the carbon–nitrogen bonds. N-Hydroxyphthalimide ethers, on the other hand, are colorless and provide O-alkylhydroxylamines by alkaline hydrolysis or cleavage through hydrazine hydrate. The "phthalylhydroxylamine" reported by Cohn was known to have a molecular formula of C8H5NO3, but the exact structure was not known. Three possibilities were discussed and are shown in the Figure below: a mono-oxime of phthalic anhydride ("phthaloxime", I), an expanded ring with two heteroatoms, (2,3-benzoxazine-1,4-dione, II), and N-hydroxyphthalimide (III). It was not until the 1950s that Cohn's product was definitely shown to be N-hydroxyphthalimide (III).
=== Names === Atomoxetine was originally known as tomoxetine. It was renamed to avoid medication errors, as the name may be confused with tamoxifen. In India, atomoxetine is sold under brand names including Axetra, Axepta, Attera, Tomoxetin, and Attentin. In Australia, Canada, Italy, Portugal, Romania, Spain, Switzerland, and the US, atomoxetine is sold under the brand name Strattera. In France, hospitals dispense atomoxetine under the brand name Strattera (it is not marketed in France). In the Czech Republic, it is sold under brand names including Mylan. In Poland, it is sold under the brand name Auroxetyn. In Indonesia, it is sold under the brand name Xenocy. In Iran, atomoxetine is sold under brand names including Stramox. In Brazil, it is sold under the brand name Atentah. In Turkey, it is sold under the brand names Attex, Setinox, and Atominex. In 2017, a generic version was approved in the United States.
Sources: en.wikipedia.org
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.
The solid is generally kept cold, dry, and protected from light. Solutions are often frozen in single-use aliquots to reduce repeated freeze-thaw cycles.
It indicates a material sold for laboratory study, not for human use. The label does not guarantee pharmaceutical purity, sterility, or regulatory approval.
It is usually detected by LC-MS or HPLC-UV against a reference standard. In biological matrices, metabolite targeting can improve detection. No universal immunoassay is widely available.